Ethernet to RS232/422/485 Serial Converter  USR-N510

1. Hardware Installation

Use a standard Ethernet cable to connect the USR- N510 to an Ethernet router or connect it directly to a PC.

RS-232/422/485 can connect with a PC or other serial port device by serial cables.

 

2.Serial Port

RS-232 DB9 Male Port RS-485/422 Terminal header ( Will provide connector)

DB9 PIN	RS-232	RS-422	RS-485 Half Duplex
1
2	RXD	RX+
3	TXD	TX-	Data-
4
5	Ground
6
7	RTS	TX+	Data+
8	CTS	RX-
9

 

Flexible shift among rs232,485 and 422

 

3. Software Installation

Download Setup/Test program from website

Install Virtual COM software- VCOM https://www.usriot.com/p/rs232rs485rs422-serial-ethernet- converter/ Note: Be sure you have administrative rights and disable any firewalls/anti-virus software when install software.

Note: Be sure you have administrative rights and disable any firewalls/anti-virus software when install software.

 

4. Configure USR-N510 

Assign a static IP address to your computer in the 192.168.0.2 to 192.168.0.254 range. Mask 255.255.255.0. This is necessary to ensure that your computer can communicate with your USR-N510.

The default IP address of USR-N510 is 192.168.0.7 Open your web browser and enter this IP to connect to USR-N510 for configure. 

 

Default Parameters
User Name	admin
Password	admin
IP address	192.168.0.7
Mask	255.255.255.0
Gateway	192.168.0.1
Work Mode	TCP Server
Local Port	8899
Baud Rate	115200
Parity bit/Data bit/Stop bit	None/8/1

 

5.Product Display